Panasonic WV-BM1400 - Manual (Page 5)

11. Video Input Connector (VIDEO IN)
This BNC type connector is used for supplying the
video signal from a source to be monitored, such as a
VTR.
12. Video Output Connector (VIDEO OUT)
This BNC type connector is used to provide the video
output signal of the source to an additional monitor or
video tape recorder.
13. DC Restoration Switch (DC RESET, ON/OFF)
■ This switch is used to restore or stabilize the dark
areas of the picture.
14. H. AFC Selection Switch (H. AFC SHORT)
Select the SHORT position for VTR playback. Select
the LONG position to monitor source timing instabili­
ties.
15. Internal/External Selection Switch (SYNC, INT/EXT)
EXT : Set the switch to this position when a non-com­
posite video signal is supplied to the Video Input
Connector and a separate sync signal is supplied
to the Sync Input Connector.
INT : Set the switch to this position when a composite
video signal is supplied to the Video Input
Connector.
16. Sync Input Connector(SYNC IN)
17. Sync Output Connector(SYNC OUT)
18. AC Inlet (AC IN)
Connect the Power Cord (provided) here.
CAUTION :
The Power Cord(provided) is designed for use with
, 100-120VAC.
When operating this unit with other than 120V AC,
replace the power cord with one approved by local
safety regulations.
Power Cable
1. Keep the Power ON/OFF switch of the camera in the
OFF position during installation.
2. Connect the Power Cord to a grounded electrical out­
let.
Video Cable
Use a 75-ohm coaxial cable (RG-59, RG-59A/U, RG-
59B/U, RG-59/U, RG-6/U, or RG-11/U).
1. Up to 10 monitors can be hooked up in this configura­
tion before signal loss occurs. Total cable length
should not exceed 500 feet.
CONNECTIONS
Camera
d
Coax.
Cable
Monitor
----- VIDEO —-
IN OUT
Coax.
Cable
Monitor
----- VIDEO —
IN OUT
2. Wiring Precautions :
Do not bend coaxial cable into a curve whose radius
is smaller than 10 times its diameter.
Never staple coaxial cable - not even with circular sta­
ples.
Never crush or pinch the cable.
All of the above will change the impedance of the
cable and cause poor picture quality.
External Sync
When a non-composite video signal is connected to this
monitor, it will be necessary to connect an external com­
posite sync signal to the monitor.
1
.
2,
Supply the sync signal source to the Sync Input
Connector on this monitor by using a coaxial cable.
Set the Internal/External Selection Switch(15) to the
EXT position.
-
3
-