Setup, Tad/fax mode, Setup tad/fax mode – Panasonic Compact Plain Paper FAX KX-FP270 User Manual

Page 89

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Setup

TAD/FAX mode

-...............-

(using the built-in answering device and receiving voice

and fax calls automatically)

When you turn on AUTO ANSWER {the pre-selected setting is TAD/FAX), the unit will work as a facsimile
machine and/or answering device.

If a fax call is detected, the unit will automatically switch to receive faxes.

If a voice call is detected, the answering device will begin recording and the caller can leave a voice message.

• You can use a pre-recorded greeting message (see page 90) or record your own greeting message (see

page 91).

Setting up the voice message and document reception

The total recording time (including the greeting messages) is about 18 minutes. If messages are recorded in a

noisy room, the recording time may be shortened up to 11 minutes.

To set the unit to record incoming voice messages and receive fax documents, follow the steps below.

1

2

Select “TAD/FAX” in step 4 of feature setting #77
(see page 73).

If the AUTO ANSWER light is off, turn it on by

pressing (AUTO ANSWER]-

• The unit will play the TAD/FAX greeting message

and the display will show the following message.

Display:

TAD/FAX MODE

The remaining time for recording incoming

messages will be displayed.

Example:

TIME = 10ml3s

o ?

O 5-

(fi

Note:
• Each incoming message recording time can be set to either 1 minute or unlimited. To change the setting, see

page 106.

• When the remaining time is low, erase unnecessary messages from memory (see pages 94 and 100).
• While an incoming call is being recorded, you can monitor it through the speaker. If this feature is not

required, set the ICM monitor feature to “OFF" (see page 107).

89

Advertising
This manual is related to the following products: