Speaker system connection, Attaching the speakers, Detaching the speakers – Panasonic RX-DT600 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Speaker system connection
This unit can be used as a one-piece portable stereo radio cassette
recorder, or a three-piece component system, by attaching or de
taching the speaker system.
Before attaching or detaching the speakers, be sure to disconnect
the speaker cables from the speaker terminals. Be sure to set
SELECTOR to TAPE/ gridJ to turn off the unit before connecting/
disconnecting the speaker cabies.
Attaching the speakers
Align the speaker with the main unit as shown in the figure, interlock
the grooves and press down.
Connect the speaker cable (black) to the © (negative) speaker
terminal, and the other speaker
cable (red)
to the © (positive)
When using the unit with the speakers attached, wind the speaker
cabies as shown.
Since a strong magnet is used for the speaker, keep magnetized
commuter passes, tickets or personal credit cards, recorded tapes,
watches, etc. away from the set. The speaker magnet in the set may
damage them.
Detaching the speakers
Unlock the speaker release levers by pulling them in the direction
shown below, and slide each speaker up.
Connect the speaker cables to the speaker terminals.