Panasonic NI-860R - Manual (Page 6)

3. Set the temperature selector dial to the "o" or (steam) zone.
"O" zone: Low steam, for thin or delicate fabrics requiring a small amount of steam.
zone: High steam, for fabrics requiring a lot of steam. ( i. e. thick materials,items
with stubborn wrinkles.)
4. Preheat the iron until the indicator light goes out, usually about 1-2 minutes.
This light will go on and off during ironing to indicate the temperature chosen by the selector
dial is being maintained.
5. Hold the iron horizontally and press the steam button into the steam position.
Steam button is regulated as follows
NOTE: 3 position steam button.
V Pry
Low steam High steam
(Button UP: for High steam. MED: for Low steam)
Temperature Zone Steam Button Position
iCi.
j H L o r M
Now steam ironing can begin
6. Anytime the iron is set vertically the steaming action will stop.
NOTE: Do not use the steam button unless the iron is sufficiently hot enough to produce steam,
otherwise water will leak out through the vents instead.
HOW TO USE AS A DRY IRON
1. Press the steam button down to the dry position.
2. Place the iron vertically, set the selector dial to OFF.
3. Plug in the iron.
4. Set the temperature selector dial to the desired position.
(Refer to the Fabric Ironing Chart in this manual on page 10)
5. Preheat the iron until the indicator light goes out, usually about 1-2 minutes.
HOW TO USE THE SPRAY FEATURE
Before using the spray feature, check the garment label for ironing instructions because some
fabrics may spot or stain with moisture. The spray feature is particularly helpful for removing
stubborn wrinkles and where extra dampening is needed.
-
6
-