Vertical steam, Warning, Self-cleaning – Panasonic NI-860R User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

1. Fill the iron as described in "HOW TO FILL"

2. Set the iron vertically and make sure the temperature

selector dial is set to OFF.

Plug the AC cord into the electrical outlet.

3. Set the temperature selector dial to the "

"

indication area.

4. Preheat the iron until the indicator light goes out,

usually about 1-2 minutes.

5. Simply pump the jet of steam button when it is desired.

But pump the jet of steam button several times before

using for the first time at each ironing session.

6. Allow at least 5 seconds between uses of jet of steam

to prevent water spotting. Use a press cloth if necessary.

VERTICAL STEAM

To get better results when using vertical Jet of steam,

hang the garment on a clothes hanger. Curtain and drapes

may also be steamed once they're hung. Hold the iron
away from your body close to but not touching the fabric.

Pull the fabric tight with your free hand and pump the

Vertical steam button (Jet of Steam Button) at 5-second

intervals as you pass the iron over the wrinkled fablic.

WARNING:

Never iron clothes on the body or point your iron at anyone

when steaming.

Keep hands and body away from steam areas while
using vertical steam feature.

SELF-CLEANING

With the self-cleaning feature you can flush out mineral residues from the steam generating
chamber and the steam vents - refreshing your iron each time for a longer steaming life.

It is very important to operate the self-cleaning feature after each steam ironing to prevent
mineral accumulations from hardening.

1. Check water level. Waterjeye[ should be at the 1/2 full. When water level is below 1/2 full, fill

with water according to the instructions in "How to Fill".

2. Preheat at "6" setting, (in about 1-2 minutes)

Make sure that the steam button is in the Dry position.

3. Set the dial to OFF and remove the AC plug.
4. Hold the iron horizontally over the sink.
5. Pump the "Jet of Steam" button quickly (at least 3

times per second) about 20-30 times.

6. White self-cleaning, pitch the iron up and down slowly

to help clean the entire inside and let the water drip
out of the sole plate vents.

-

8

-

Advertising