Panasonic PV-GS80 - Manual (Page 18)

Before using
Q uick Start
When Quick Start is ON the battery power is stiil
being consumed, even when the LCD Monitor
and the Viewfinder are closed.
The Camcorder will resume recording/pause
mode about 1.7 seconds after the LCD Monitor
and the Viewfinder are reopened.
• Please note in Quick Start Mode approximately
half the pause recording power is being
consumed.
Using Quick Start Mode will reduce the battery
recording/playback time.
•This is only activated in the following cases.
•While using the battery
A tape or a card is inserted while Tape
Recording Mode is set.
A card is inserted while Card Recording
Mode is set,
•While using the AC adaptor
Quick Start can be used even if a tape/card
is not inserted.
• Set to Tape/Card Recording Mode.
1 Set [SETUP] » [QUICK START] » [ON],
(-2:;.)
2 While the [OFF/ON] switch is still set to
[ON], close the LCD monitor and retract the
Viewfinder.
сЩа„
OFF ON
• The Status indicator lights green and the unit
goes into quick start standby mode.
• The Camcorder will not go into quick start
standby mode unless the LCD monitor is
closed and the viewfinder is retracted.
Open the LCD monitor or extend the
Viewfinder.
;€>-сда...
OFF ON ®
• The Status indicator lights red and the
Camcorder is put into recording pause
approx. 1.7 seconds after it is turned on.
I To cancel Quick Start
1 Set [SETUP] » [QUICK START] » [OFF].
(-23-)
• If the [OFF/ON] switch is set to [OFF] while the
unit is in quick start standby mode, the power
turns off.
• If the standby continues for approx. 30 minutes,
then the Status indicator will go oft and the
Camcorder will be completely turned off.
• In the following oases, quick start is canceled
and the power turns off.
•When the Mode dial is moved.
•When the battery or AC adaptor is removed.
•When both the tape and card are removed
while using the battery in Tape Recording
Mode,
•When the card is removed while using the
battery in Card Recording Mode.
• When the Camcorder is quick-started with the
white balance on automatic, it may take some
time untii the white balance is adjusted if the
scene being recorded has a light source
different from the scene last recorded, (When
the MagicPix function is used, however, the
white balance of the scene last recorded is
retained.)
• If the power is turned on in quick start standby
mode, the zoom magnification becomes 1X and
the picture size may differ from what it was
before quick start standby.
• If [POWER SAVE] {- 2S-)
is set to [5 MINUTES]
and the unit automatically goes into quick start
standby mode, set the [OFF/ON] switch to
[OFF], then to [ON] again. Also, close the LCD
monitor and retract the viewfinder and then
open the LCD monitor or extend the viewfinder
again.
18
LSQT1121