Panasonic NV-HS1000EC - Manual (Page 49)

Programme Editing
Edit Timing Adjustment
When performing editing in conjunction with a unit which
has a different mechanism, there may be a lag in the edit
start point due to a deviation between the time a pause
cancellation signal is received by the recording unit and the
time recording actually begins.
Edit Timing Adjustment is used to compensate the edit start
and end time in light of this start-up time deviation,
1 Record the second hand on a stopwatch with a movie
camera.
2 Insert this recorded cassette into the playback unit, and a
cassette with an intact erasure prevention tab into the
recording VTR.
3 Using the point where the second hand reaches zero as
the edit start point, perform copying.
4 Play back the copied tape, and check how many seconds
had elapsed at the recording start point.
• If timing is correct, recording should begin at exactly
zero seconds.
5 Select TIMING ADJUST from the screen below.
7 Adjust the timing for the start point by setting the amount
of the discrepancy of the second hand.
•The setting is displayed in frame {Vzs of a second) units.
Thus If, for example, one second had elapsed, set to
-25,
•Corrections can be made in the range of ±30 frames
(1.2 second).
: •t. '/
U
sa£i± rs.B
waste..
8 Adjust the timing for the end point in the same manner.
TllWAtfi/ADJUST-" ^
2;. MARK OUT,”
^ SEt£Crr:'''V- 'iWMr
Note:
Edit timing adjustment function only works during
programme editing.
To cancef All Editing Programmes
1 Select ALL CLEAR from the screen below.
6 Press ENTER,
CO
C
.o
2
03
CL
o
03
.c
.■tt
2 Select YES.
•All programmes will be canceled.
49