How to deregister your handset(s) – Clarity D704HS User Manual

Page 7

Advertising
background image

10

11

• Then press # on handset.

4. To register the handset(s) to the telephone base again, follow

the registration instructions in section Register a handset.

NOTE: There are no visual or audible alerts to indicate
the base is under deregistration mode.

If the base of your main unit is represented by the drawing below,
follow the directions below the drawing:

1. Press and hold FIND on the telephone base for about 10

seconds, until the SPEAKER light starts flashing; release FIND.

2. Immediately press FIND again; you will hear two quick beep

tones.

3. When complete, the handset screen alternately shows

• Press FIND on base 4 sec

and

• Then press # on handset.

4. To register the handset(s) to the telephone base again, follow

the registration instructions in section Register a handset.

HOW TO DEREGISTER YOUR HANDSET(S)

Note:

If the deregistration process is not successful, you might need to
reset the system and try again. To reset, unplug the power from
the telephone base and plug it back in.

You cannot deregister the handset(s) if any system handset is in
use.

Note:

If your handset is registered to a base, you can re-register it to
a different base without deregistering it from the original base.
Just follow the directions in the section How to add (register) your
handset to the main unit (sold separately).

HOW TO DEREGISTER YOUR HANDSET(S)

Advertising
This manual is related to the following products: