360 Systems MAXX-1000SD - Manual (Page 26)

Page 26 MAXX Owner’s Manual
LTC Time Code Output
An LTC time code output is provided on the LTC OUT LTC OUT LTC OUT LTC OUT BNC connector. It may be selected by
means of the On-Screen user interface to output time code from any of the three video
channels during playback. The LTC output has a source impedance of <5 ohms.
Keyboard
Attach the alphanumeric keyboard to the purple 5-pin KEYBD KEYBD KEYBD KEYBD connector to control the server
and manage clips with the On-Screen graphic user interface. Note that the server will only
recognize the keyboard if it is attached before power up.
Mouse
A two-button scroll mouse is provided with the Image Server. Plug the mouse into the green 5-
pin MOUSE
MOUSE MOUSE MOUSE port. Do not use the USB ports, even if the supplied mouse is USB capable. Note
that the server will only recognize the mouse if it is attached before power up.
Monitor
A VESA-compliant computer monitor may be connected to the 15-pin VGA video port. The
Image Server resolution is fixed at 1024 x 768 pixels, with a refresh rate of 72 Hz. This is best-
viewed on 17-inch or larger monitors. 360 Systems does not provide monitors for the server.
Note: Do not use older monitors that are not VESA compliant. The server may not start
properly if an unsuitable monitor is connected.
Serial Port
The system board serial port is not used. Make no connection.
USB Ports
The system board USB ports are not used. Make no connection.
Power
An IEC mains socket is provided on the rear panel for power input. The Image Server will
accept world-wide power sources in the range of 100-240 volts AC, 50-60 Hz. The server is
shipped with a power cord appropriate for the region in which it is sold. Replace the power
cord only with one of the same type and rating.
DO NOT use the power supply switch to shutdown the Image Server. (See the section
Shutting Down Image Server on the next page.) The rear panel power switch should only be
used if the Image Server fails to shutdown after holding the front panel power switch for 4
seconds, and the shutdown procedure from the GUI is not possible. The rear panel power
switch can be used to prevent the application of power during service procedures once the
normal shutdown sequence has completed.