360 Systems Short/Cut Editor - Manual (Page 24)

Page 16 Rear Panel Features
360 Systems
Digital Audio Outputs
A male XLR-3 connector provides a digital output in the AES/EBU format. A BNC
connector provides a 75-ohm output in the professional AES-3ID format. Digital output in the
IEC-958/II format is not provided.
D-NET File Transfer Ports
The XLR and BNC digital outputs may be used as D-NET file transfer ports. D-NET is
an audio network using standard digital audio protocols. It can transfer files with their names
and audio data to 360 Systems DigiCart/II and Instant Replay units.D-NET signals from other
360 Systems devices can be Echoed through the Shortcut by connecting them to either the XLR
or BNC digital inputs.
Power Supply
The power supply can be used with any voltage between 85 and 260 volts at 50 or 60
Hz. It is not necessary to switch it when making connection to different voltages. A
detachable IEC mains cable is provided, with a connector appropriate for the destination
country.
Power Switch
The power switch is located on the left edge of the rear panel, as viewed from the front of
the Editor. The designation "1" means ON and "0" means OFF .
NEVER TURN THE POWER OFF OR DISCONNECT THE
POWER CORD WHEN THE SHORTCUT EDITOR IS
ACTIVELY PERFORMING ANY TASK.
Headphone Jack
A stereo 1/4” (6.35mm) female jack is provided for headphone monitoring.
Display Viewing Angle (Contrast Control)
A rotary control adjusts the viewing angle of the LCD display.
Serial Number
The serial number of the Shortcut Editor is affixed to the right side of the rear panel, as
viewed from the rear. This coded number also contains the date of manufacture. The serial
number should also appear on the inside front cover of the owner's manual.
GPI and Tally Outputs
GPI inputs for S TOP , R ECORD , P LAY , R EWIND , F AST F ORWARD and Speaker Mute, plus tally
lamp outputs, are provided on a 15-pin D connector. These inputs can be reassigned in various
combinations in the Setup Menu, allowing their use with Pause and up to four Hot-Keys. A
contact closure to common will assert a GPI command. A +12 volt source and open collector
outputs are provided for tally LEDs. The connector pinout and assignment options are
presented below. Reassignment procedure is covered on page 59.