360 Systems Short/Cut Editor - Manual (Page 54)

Page 46 Editing
360 Systems
•
Insert Record
•
Erase
•
Gain Adjust, Set and Fade
•
Bleep
An individual track is selected with one of the A RM keys. In normal editing, both A RM
keys illuminate when entering the Edit mode. A single track can be de-selected by pressing its
A
RM key; note that its LED is now OFF . The state of the A RM buttons is remembered when the
file is saved. This can be used as a “safety” of sorts by turning off both A RM buttons when
saving a finished file.
Editing operations are performed on a single track the same way as on a stereo pair. Note
that Locate Marks and Edit Marks are normally placed on both tracks together; in the case of
single-track operations, it is possible to perform edits that will move these marks apart from
each other, or even erase the mark for one track while leaving the other in place.
L
R
SHORTCUT PROMO 0:01.95
TIME OFFSET BETWEEN LOCATE MARKS ON THE LEFT
AND RIGHT TRACKS DUE TO SINGLE-TRACK EDITING.
Location Marks can be placed in a single track by placing them with only one track
armed. When one track is armed, the Go To keys will only locate to Marks in the armed track.
If neither track is armed, Go To will only locate to the beginning and end of the file, the Edit In
and Edit Out Marks, and the Zero Mark.
When material is Cut or Copied from a single channel, it will appear as two channel in the
resulting Hot Key or _ CLIPBOARD file, with the audio only existing in the channel that was
armed when the file was created. However, if it is inserted into a file with the opposite channel
armed, the material will “cross over” to the other channel. This can be used to switch channels
for a short segment, create a two channel mono file from a single channel mono file, or swap the
channel of a stereo file. Remember that you must create the file with a single channel armed,
and Insert the file with the opposite single channel armed.
If you Insert stereo material into a file with only one track armed, the left channel of the
stereo material will be inserted into the left track if it is armed, or the right channel material will
be inserted into the right track if it is armed.