acidlab Autobot - Manual (Page 15)

15
Programming Shuffle (Pattern Write Tap Mode)
The Autobot has two kinds of Shuffle:
- The first kind of shuffle delays the even numbered steps (2, 4, 6, ...).
This is similar to the common shuffle found on the 909.
- The second kind of shuffle delays steps 3, 7, 11 and 15. This second kind of
shuffle is similar to the one on the CR-8000.
Both shuffles can be applied simultaneously.
Each of the two shuffles can be adjusted over a range of 4 degrees.
To do so, press the Select and the Length/Shuffle buttons at the same time.
LEDs 1-4 of the step buttons will now indicate the shuffle setting of the first kind of
shuffle.
LEDs 5-8 indicate the shuffle setting of the second kind of shuffle.
Keeping the Select and Length/Shuffle buttons held, you can now press the
corresponding Step buttons 1-4 or 5-8 to adjust the shuffle.
When shuffle is set to step 1 and step 5, no shuffle is present.
If the Scale is changed, the shuffle settings return to the default setting (no
shuffle)!