Adaptive Technologies 4X4-UD46A-VWD - Manual (Page 2)

© 2011 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-120712
Step 1: Assemble Top Left Frame
Place all of the parts in figure 1A on the floor. Start with three
9-0803 2X V-channels with their open side facing up with the
narrow part of the key holes slots facing up and all in the
same direction. Place four 9-0802 Left H-Slats over the V-
channels with the keyhole surface facing up and the four-hole
patterns lining up with that of the channels (Figure 1A).
Rectangular slots in the ends of the slats should be at the
outer edge of the frame. (See figure 3).
Step 2: Assemble Top Right Frame:
Place all of the parts in figure 1B on the floor. Start with three
9-0801 2X V-channels with their open side facing up with the
narrow part of the key holes slots facing up and all in the
same direction. Place four 9-0801 Right H-Slats over the V-
channels with the keyhole surface facing up and the four-hole
patterns lining up with that of the channels (Figure 1B).
Rectangular slots in the ends of the slats should be at the
outer edge of the frame. (See figure 3).
Step 3: Assemble Bottom Left Frame:
Place all of the parts in figure 1C on the floor. Start with
three 9-0803 V-channels with their open side facing up with
the narrow part of the key holes slots facing up and all in the
same direction. Place four 9-0802 Left H-Slats over the V-
channels with the keyhole surface facing up and the four-hole
patterns lining up with that of the channels. Place three 9-
0814/9-0804 vertical joiner plates at the top of the V-channel
as shown in Figure 1C. Rectangular slots in the ends of the
slats should be at the outer edge of the frame. (See figure
3).
Step 4: Assemble Bottom Right Frame
Place all of the parts in figure 1D on the floor. Start with three 9-0803
2X V-channels with their open side facing up with the narrow part of the
key holes slots facing up and all in the same direction. Place four 9-
0801 Right H-slat over the V-channel with the horizontal keyholes
facing up. Place three 9-0814/9-0804 vertical joiner plates at the top of
the V-channels (Figure 1D). Rectangular slots in the ends of the slats
should be at the outer edge of the frame. (See figure 3).
Bottom Left Frame (Figure 1C)
Bottom Right Frame (Figure 1D)
Figure 1E (Center Joiner Assembly)