Adaptive Technologies 4X4-UD46A-VWD - Manual (Page 3)

© 2011 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-120712
Figure 4
Figure 3
Step 5: Assemble Center Joiner Assemblies:
Place one 9-0810 center joiner v-channels on the floor, each with their
opening facing up and with the narrow end of the keyhole slots facing
up. Place four each 9-0806 Horizontal Joiner plates thread side down
over the two 9-0810 center v-channels as in Figure 1E and 2.
Step 6: Install Locking Arm brackets
Assemble the 9-0812 locking arm bracket on four of the 9-0802 left H-
slat and four on the 9-0801 right H-slat near the rectangular slot using
the provided M4 screws, nylon washer and nylock nut (Figure 4). The
locking arm brackets must be installed on the first, third, fifth and
seventh horizontal H-slats starting from the top. Make sure the hook of
the locking arm bracket faces up (Figure 4 & 5). Tighten screw to
increase locking arm friction.
Step 7: Assemble the Four Sections of the Frame
Assemble the top left frame by attaching the horizontal H-slats,
(9-0802 , 9-0801) to the V-channels (9-0803) using the
provided M6x20mm long flat head screws. Do not tighten
screws until all screws are installed. Check for squareness by
measuring corners to corners then tighten screws starting with
the screws on the holes of the H-slats (Figure 6)
Repeat step 4 for assembling the top right frame, lower left
frame and lower right frame (Figure 6).
Step 8:
Join the top left frame and the top right frame together using
the 9-0806 horizontal joiner plate and 9-0810 4Xcenter joiner
V-Channels (Figure 7 & 2). Tighten screws permanently.
Step 9:
Assemble the bottom left frame and the bottom right frame
together using the 9-0806 horizontal joiner plate and 9-0810 4X
center joiner V-channels (Figure 8 & 2). Tighten screws
permanently.
Step 10:
For wall installation, refer to product installation guide.
Figure 2