Adaptive Technologies LTMB24 - 1x3 - Manual

© 2008 ATM FLY-WARE Signal Hill, CA 90755 USA (562) 424-1100 030310-REV01
LTMB24-X3-RK
Installation Instructions LT MB24 3 Wide Rigging Kit Grid
Thank you for choosing the LTMB24-X3-RK Grid. This grid
suspends 3 BOSE LT MB24-III speakers in 3 sequential
arrangements.
Important: Rigging overhead system requires
professional experience. Improperly installed equipment
can result in property damage, personal injury, death
and/or liability to the installing contractor. Do not
suspend if in doubt about the integrity of the structure.
Caution: Due to the wide variety of structures,
environments, materials and rigging methods, the installing
contractor should exercise good judgment in selecting the
proper mounting area and hardware.
Follow these instructions for the most efficient and
safest rigging results. Do not exceed the working load
limit of 1000 lbs/455 Kg.
Package Contents:
1 pcs. LTMB24-X3-RK GRID
1 pc.
Instruction sheet, 8.5X11
12 pcs Hex Cap, 3/8-16x1.5,G8, blk
12 pcs. Split washer, 3/8, G8, blk
12 pcs. Flat washer, 3/8”, SAE, blk
Step 1:
Check to make sure the holes of the grid matches the holes on
top and bottom of the speaker. Remove and discard speaker
screws where the grid will be attached
Step 2:
Set three speakers on the clean or padded floor with the front
facing the same direction. Lay the grid over the top of the
speakers and match the holes to the holes on the speaker.
Attach grid to speakers using the supplied 3/8 hex bolt, washer
and split washers. Tighten bolts permanently (Figure 1).
Step 3:
Attach load rated suspension cables to the suspension bracket
on the four corners of the grid using load rated hardware such
as shackles (Figure 2). One can use six cable suspension
points or six points bridled to a three point suspension (Figure
2). .
Step 4:
Check all connections before suspending the speaker cluster.
Step 5: Connecting the 2 nd Tier of LTMB24 loudspeaker
Repeat step 1 and 2 for the 2 nd tier of speaker (Figure 1)
Figure 1