A-Designs MP-2A - Manual (Page 6)

6 | Stereo Tube Mic Pre, MP-2A ™ Owner’s Manual
Functions
Front
1
Level Control Knobs - These knobs are just that. They will control the level/pad of the incoming signals.
2
VU Meters - Meters provide general indication of level. They are set to -4dB.
3
Direct In
4
Polarity Switch (0 to 180)
5
Pad Switch (+20dB)
6
Phantom On/Off - The Phantom Switch gives you the option to use various types of Microphones.
If you are using a Condenser Microphone please make sure you have the Phantom Switch in the on position. If
you turn the Phantom Power Switch off while the Mic is still plugged in there will be a 5 second delay before it is
completely off.
7
Tone Switch 1/2 - This switch will allow you to set your outputs to your configuration.
8
Tone Switch 3/4 - This switch will allow you to set your outputs to your configuration.
9
Heat Vents - Allow the flow and circulation of air to cool the tubes and transformers.
10
Power Switch - Large size for easy operation up and down (on/off).
11
Power Light Indicator - Red Jewel light indicator. When power is on the light will illuminate.