A-Designs MP-2A - Manual (Page 7)

Owner’s Manual | 7 Stereo Tube Mic Pre, MP-2A ™
Functions (continued)
Back
12
AC Power Connector - For electrical outlet (Caution: please check to see what Voltage your MP-2A is set to). If
the Voltage Box is not marked according to your country’s code please notify A Designs before powering up.
13
Fuse Amperage - These are placed on the MP-2A to indicate which voltage your unit is set up for. USA Voltage
should be set to 120v. For export to countries with 220v, the correct box should be marked at the back of the unit.
If not marked or marked incorrectly, please notify A Designs before you turn your unit on!
14
Fuse Box - This box acts as a fuse container draw. The Fuse draw will slide in and out for easy access to change
your fuse, as necessary.
15
Heat Vents - Allow the flow and circulation of air to cool the tubes and transformers.
16
XLR Outputs (balanced) - The XLR output is balanced out and you have the option to change the output
ohms from the face of the MP-2A (600 ohms/ 10k) by using the OUTPUT Switch located on the front panel of
the MP-2A. XLR’s are clearly marked indicating which Channel is being used.
17
XLR Inputs (balanced) - The XLR input is used for Microphones. You can use the inputs for other instruments.
If you are using a condenser Microphone, please make sure your Phantom Power is in the on position. The
Phantom Power switch is located on the front panel. (See Illustration 1). XLR’s are clearly marked indicating
which Channel is being used.
18
Serial Number - If this serial number is removed or tampered with, your warranty will be void.
The MP-2A has a 2U rack space which fits nicely into any Studio Rack and will compliment your array.
UNIT SIZE:
Width: Standard 19 inches for easy Rack Mount installation.
Height: Standard 3.50 inches or 2U Rack Space.
Depth: 10 inches
Weight: 18 lbs 8.16 kg.