Analogue Solutions Oberkorn sequencer - Manual (Page 18)

Oberkorn User Manual
18 SEQUENCE CONTROL | Analogue Solutions
IN Socket
If you want to sync Oberkorn from an external clock source, use this socket. You can use
one of Oberkorn’s MIDI-Trig outputs here to allow you to clock from a MIDI note.
You might want to use the clock output from another analogue sequencer here, or even the
square wave output from an LFO.
Oberkorn as a VCO
Note: you can clock Oberkorn using the square wave from a VCO! This was Oberkorn will
step at audio frequencies. Take a CV output into your audio mixer (watch the signal levels)
then use the 16 CV controls to adjust the shape of the waveform!
OUT Socket
Which ever clock source is selected using the Run/Stop switch, is thru’ed to the out socket.
If the Run/Stop switch is left, then the internal clock signal is sent out.
If the Run/Stop switch is right, then the external clock signal is sent out.
If the switch is in the centre (off) then no signal is sent out.
Daisy Chain Synchronization
Use this socket to daisy chain and sync other analogue sequencer’s to Oberkorn.
CV Socket
The internal clock speed can be changed via an external CV.
Rub/Stop will have to be set left (INT) so the internal clock is used as a sync source.
Make sure the TEMPO control is set below maximum.
Plug an external CV into the CV socket, for example, output from an envelope or LFO.
The clock speed will change according to the input voltage.
Weird?