Aviom A-16D Pro - Manual (Page 13)

6 A-16D P
ro
A-N
et
D
istributor
u
ser
G
uiDe
Pre‑made cables in a variety of lengths and colors are available at most
computer outlets. Cables can be extended by using a simple passive device
called an inline coupler to add length to existing cables (as long as you do not
exceed the specified maximum cable length). If you need a longer cable on
occasion, this is a simple solution. Note that it is possible that the maximum
cable length specification can be compromised by using inline couplers or
other passive connection devices.
AC Line Conditioning
Aviom products are digital devices and as such are sensitive to sudden spikes
and drops in the AC line voltage. Changes in the line voltage from lightning,
power outages, etc., can sometimes damage electronic equipment.
To minimize the chance of damage to your equipment from sudden changes
in the AC line voltage, you may want to plug your equipment into a power
source that has surge and spike protection. Power outlet strips are available
with built‑in surge protection circuits that may help protect your equipment.
Other options for protection of your equipment include the use of an AC
line conditioner or a battery backup system (sometimes referred to as an
uninterruptible power supply, or UPS).
Installing in an Equipment Rack
The A‑16D Pro is designed to be installed in a standard 19‑inch audio
equipment rack. This design is both for easy transportation of the unit and
for protection. Each unit takes up two standard rack spaces (19 inches wide
by 3.5 inches high).
The rack ears on each side of the device are designed to support the weight
of the A‑16D Pro. Each rack ear contains holes for two screws per side. Always
support the unit with all four screws.
The rear panel of the A‑16D Pro also includes mounting holes for adding rear
support. Support the rear of the A‑16D Pro if it is mounted in a rack that will
be transported frequently to avoid flexing the case of the product.
To rack mount the A‑16D Pro, position it in the equipment rack at the desired
location. Use standard rack‑mounting screws (10‑32 size) to attach the unit to
your rack hardware. Tighten all four screws firmly, but avoid overtightening.
You may want to use non‑metallic washers between the rack‑mounting
screws and the device’s finished surface to avoid marring the painted finish
on your Aviom products.