Aviom A-16D Pro - Manual (Page 14)

7 A-16D P
ro
A-N
et
D
istributor
u
ser
G
uiDe
Always allow adequate ventilation for devices mounted in equipment
racks. Avoid placing your Pro16 product directly above or below other rack‑
mounted devices that produce high levels of heat, such as power amps.
EtherCon Connector
Some Aviom products use EtherCon® Cat‑5 connectors. The Neutrik EtherCon
connector is a dual RJ45 type connector. It can receive a standard Cat‑5e
cable or a cable fitted with the special heavy‑duty EtherCon connector.
When using a standard Cat‑5e cable, plug the cable into the center of the
jack; release the cable by pressing on the small plastic tab built into the cable
connector.
The locking EtherCon connector is similar to an XLR cable, the kind commonly
used on microphones. Insert an EtherCon equipped cable into the jack until
it clicks and locks in place. To remove the cable, press on the metal release
tab at the top of the panel‑mounted EtherCon jack and pull the connector
outward.
Cleaning and Maintenance Information
The exterior of your Aviom products should be cleaned with a dry, soft, lint‑
free cloth. For tougher dirt, you can use a cloth slightly dampened with water
or with a mild detergent.
When cleaning your Aviom products, never spray cleaners directly onto the
product surfaces. Instead, spray a small amount of the cleaning solution onto
a clean cloth first. Then use the dampened cloth to clean the product.
P N
ote
: Never use solvents or abrasive cleaners on the finished surfaces of
your Aviom products.