Bio Bidet Prestige Luxury Class Bidet Seat BB-800 - Manual (Page 20)

20
TROUBLE SHOOTING
10
Trouble Cause Remedy
1.The water tank is not filled.
2.The shut off valve is closed.
3. Freezing inside the main unit
or the water supply pipe.
1.Disconnected the power cord.
2.The seat is not occupied.
3. The battery of remote
controller is exhausted.
(Only BB-1000 model)
1.Check the water supply system
1.The water pressure level is set to
“ LOW”.
2.The strainer is clogged.
1.The water temperature is set to
“ LOW”.
2.Continuous operation has
depleted the supply of warm
water.
1.The seat & dryer temperature is
set to “LOW”
1. Wait about one minute.
2.Press the desired washing
button once again.
3.Turn on the shut off valve to
open.
4.Heat the room (for about two
hours). Operating the unit while
parts are frozen will cause a
malfunction.
1.Connect the power cord.
2. Check the power supply
system in your house.
3.Occupy the seat (The unit has
an occupied sensor).
4.Replace the battery.
1. If water is leaking from the
main unit, call the service
center or the place you
purchased unit.
1.Set the water pressure to
“ HIGH”.
2.Clean the strainer.
1.Set the water temperature to
“ HIGH”
2. Wait about three minutes.
1. Set the seat & dryer
temperature to “HIGH”.
The washing water
does not spray
The unit is not
operating
Water is leaking
The washing water
pressure is weak
The washing water
is not warm
The seat and dryer
is not warm
Installation Manual and Operating Instructions
lifestyle Upgrade
BB-800_1000 2013.3.26 3:10 PM 페이지21 mac001 JETPDF 2540DPI 175LPI