COP-USA AU40Z - Manual (Page 6)

5. -P、PELCO-D、ALEC、Ultrak Available） Set the cruise track （Minking A01/B01、PELCO
z Enter the status of track setting：[SHOT]+[N]+ [ON] (N：No. of track from 1 to 6).
Display：Track = 01 Sum = 06
Description：Track No is currently 1 set, in which there are 6 preset points.
. Each track involves 16
track is 01.
z Edit Track：Press [TELE] to edit afterward and press [WIDE] to edit return
preset points and the running speed and the dwelling time of each preset position.
Display：No.：01 Point：001 → Description：The 1st preset position in the
Display：No.：01 Speed：001 → Description：The speed of the 1st preset point in the track is
the 1st class.
Description： Display：No.：01 Time： 004 → The dwelling time of the 1st preset point in the
track is 4 seconds
o the lowest. Any s
z Speed Range：1 to 8 from the fastest t
peed outside the range well be referred as
z
oints before the No. N preset point in
z
store and exit while push the joystick to exit without storage.
6.
the 1st class; the range of the dwelling time is：1 to 99.
When the No. N preset point is set as No. 0, then all preset p
the track will be valid however all numbers of preset points afterward and their speed and dwelling
time shall be set as 0 automatically.
After tracks are edited, press OFF to
Tour the Track：[SHOT]+[N]+ [Enter]
Display：Input Tour No：01
Description：N –– No. of the track from 1 to 6.
shing the joystick. Function：Tour the No. N track and stop tour by pu
7. Stop the Track: [SHOT]+[N]+ [OFF]
Display：Input Tour No：01
Description：N –– No. of the track from 1 to 6.
ushing the joystick.
8. C il “ Clear Tour OK ”appears)
Function：Stop the No. N track or stop tour by p
ancel Cruise Track: [SHOT]+[N]+ [OFF] (Pressing [OFF] down unt
Display：Input Tour No：01
Description：N –– No. of the track from 1 to 6.
ON、SAMSUNG Protocol)：[AUTO]+[P1]+[ON]+[P2]+[OFF]
Function：Delete the No. N track
9. To turn on Auto Pan (Operation of NE
Display：Input 1st No：001
Description：P1 –– the starting scan No. of preset point from 1 to 128, which should be set already.
Display：Input 2nd No：002
can No. of preset point from 1 to 128, which should be set already. If P1 =
Note: ① For P
scan position, operation
‹ an position: Transfer the Speed Dome to the ending scan position,operation
‹ AUTO]+[ENTER]
② t arameters. You must set these parameters before using a
Aut
econd specify position)
Description：P2 – the ending s
P2 or P1 and P2 are coincided, the speed dome will make scan in range of 360°.
ELCO-D、PELCO-P Protocol the way of operation is as follows:
‹ Set the starting scan position: Transfer the Speed Dome to the starting
[AUTO]+[ON]
Set the ending sc
[AUTO]+[OFF]
Run Auto Pan：[
Au o Pan operation takes the following p
o Pan command to begin the scan operation. You can use the scan stop command ot PT scan stop
command to stop the scan. Setting scan condition.
z Auto Pan Position(First specify position, s
z Auto Pan Speed and Direction