Pelco-p/9600bps, Pelco-d/2400bps – COP-USA CD52W-NV User Manual
Page 6
Operation Manual for Intelligent Speed Dome Camera
ALEC
OFF
ON
ON
ON
OFF
ON
○
Utralk
ON
ON
ON
ON
OFF
ON
○
Table 2
Some protocols and the states of the coding switches of normal baud rate of these
protocols are shown as follows:
PELCO-P/4800Bps
ON
1
2
3
4
5
6
PELCO-P/9600Bps
ON
1
2
3
4
5
6
ON
1
2
3
4
5
6
PELCO-D/2400Bps
ON
1
2
3
4
5
6
B01/9600Bps
4. Setup of the Baud Rate of Communication. As shown in Figure 2, SW2 is used to set
the protocol of communication and the baud rate used by the dome camera. DIP-6 and
DIP-5 of SW2 are used to select the baud rate of communication and 4 different baud
rates can be selected in maximum. If the controller adopts non-standard baud rate, you
can adjust it to be identical with that of the controller as per the following table.
Setup of Baud Rate
Baud Rate of Communication
DIP-1
DIP-2
DIP-3
DIP-4
DIP-5
DIP-6
2400bps
OFF
OFF
4800bps
ON
OFF
9600bps
OFF
ON
19200bps
ON
ON
5. Selection of the Terminal Resistor of the Dome Camera. As shown in Figure 2, JP is
the select switch of the 120 Ω terminal resistor on the bus RS485, on which
only one terminal resistor of the dome camera at the farthest end can be connected, while
the terminal resistors of other devices should be opened.
6. Special function control. Some special protocol such as “Santachi”,”PELCO-D” and
“PELCO-P” without the command of control some especial functions, in order to use the
special functions of dome, so we changed the command of calling/setting NO.51 preset to
NO.64 preset to control them.
Keyboard control
N
Object of control
Call the N position
Preset the N position
51
Auto scan（low speed）
Auto cruise
52
Auto scan（middle speed） Set the start point of scan
53
Auto scan
Auto scan（high speed）
Set the end point of scan
54
Camera power
Power on
Power off
55
Back light *
On
Off
56
ICR shor
On
Off
57
OSD (Some cameras have it’s
own menu, to open/close the
menu by the command “turn on
the OSD”, and use the command
“turn off the OSD” to
open/close the OSD)
On
Off
58
Digital Zoom
On
Off
59
FOCUS
Auto
Manual
60
IRIS
Auto
Manual
61
White Balance Mode
Auto
Manual
5