COP-USA ASH56NVIR-L36S - Manual (Page 7)

5
user changes the option of the laser lamp into ON by the menu, the laser system is changed into the
manual control; if changing back into the automatic control, the user should set the option on the menu of
the laser at OFF.
2.4.4 WIPER：WIPER open/close.
2.4.5 WIPER MODE：Continuous or moment mode to be selected.
2.4.6 DEFOGGER：DEFOGGER open/close.
2.4.7 RETURN： To return to the main menu.
2.5 CAMERA MASK SET
2.5.1
MASK PRIVACY: ON/OFF
2.5.2 MASK SHADE: BLACK/GRAY/WHITE
2.5.3 MASK REGION: 01-06(FCB-EX480BP)or 01-02(VK-S454E).
2.5.4 RETURN: return to Main Menu.
2.6 PROGRAM
2.6.1 AUTO PAN START POS： To set the start position of the pan
between two positions. After entering you can move the dome camera
by the joystick. Push CLOSE button you can store current position
and return.
2.6.2 AUTO PAN END POS： To set the end position of the patrol between
two positions. After entering you can move the pan/tilt by the joystick.
Push CLOSE button you can store current position and return.
2.6.3 RUN AUTO PAN： To pan between two positions. Please set the start
position and the end position of the pan first. If the start position is
just the end position, the dome camera shall make 360° pan. The
speed of the pan is divided into six grades: FAST / NORMAL /
SLOW / -FAST / -NORMAL / -SLOW. The first three grades are the pan less than 180° while the rear
three grades are the pan larger than 180°. Adjust speed by PAN LEFT/PAN RIGHT and press OPEN
button to exit the menu. The start position and the end position of the pan can be set up by options 1 and 2
of the menu.
2.6.4 SET TITLE： to edit the title of the preset position. Only first 63 positions can have their titles. Select the
number of the preset positions by PAN LEFT/PAN RIGHT and press OPEN button to enter into the edit
state. Operations under the edit state are shown below.
2.6.5 SET PATROL： to edit patrol data of multiple positions. Select the number of the pattern by PAN
LEFT/PAN RIGHT and press OPEN button to enter into the edit state. Operations under the edit state are
shown below.
2.6.6 RUN PATROL： To run patrol of multiple positions. Select the number of the pattern by PAN LEFT/PAN
RIGHT and press OPEN button to exit the menu.
2.6.7 RECORD PATTERN： To edit self-study of patrol. It can remember PTZ operation in 40 seconds in
maximum. When the 40th second is up or press CLOSE button, the edit is terminated.
2.6.8 RUN PATTERN： To run self-study pattern. After running it shall exit the menu. Control the joystick to
terminate its running.
2.6.9 RETURN： To return to the main menu.
3 Appendix to the Menu
Operation of Multiple Patrol Positions under Edit State. After entering into Edit state, operations on the
screen are as follows: