COP-USA DVR2308SE-SL - Manual (Page 19)

DVR User Manual
13
3 Basic Function Instruction
3.1 Startup & Shutdown
Please make sure all the connections are done properly before you power on the unit. Proper startup and shutdown are crucial
to expanding the life of your DVR.
3.1.1 Startup
Step1: Connect with the source power.
Step2: The device will boot and the power LED would turn blue.
Step3 A WIZZARD window will be pop-up and show some information about time zone
，time setup，network configuration,
record configuration and disk management. User can setup here and refer to the concrete setup steps from the corresponding
chapters. If users don‟t want to setup Wizard, please click Exit button to exit.
Note: This DVR can only display options on either VGA monitor or BNC monitor at a given point of time, if there is live image
display without menu options then please check if there is display on other device/monitor, or long press Fn/ESC key to wait
for login dialog box to appear. Long press Fn/ESC key can switch the output between BNC and VGA.
3.1.2 Shutdown
You can shut down the device by using IR remote controller and mouse.
By IR remote controller:
Step1: Press Power button, the shutdown window will appear. Th e unit will shut down by clicking “OK” button.
Step2: Disconnect the power
By mouse:
Step1: Enter into Menu, then select “Shut Down” icon, the shutdown window will appear
Step2: Click OK. Then the unit will power off after a while.