Cub Cadet MMZ Rider - Manual (Page 17)

Cub Cadet Commercial M60 Tank - 2002 and prior years
13
18. Remove the hairpin and clevis pin from below
the deck lift lever.
19. Push the deck lift lever down as far as it will go
and place the clevis pin and hairpin above it. See
Figure 8.
NOTE: This keeps the deck links down.
20. Remove both hex lock nuts and carriage bolts
securing the skid plate frame struts to the mid
frame of the unit using a 9/16” socket.
See Figure 9.
Figure 8
Hairpin
Clevis Pin
Lift Lever
Deck Links Down
Carriage Bolts
Frame
Hex Lock Nuts and
Struts
Figure 9
21. Remove both of the hex bolts, flat washers and
lock nuts securing the right and left hydrostatic
pumps to the frame using a 9/16” socket and a
9/16” wrench. See Figure 10.
22. Lower the skid plate assembly slightly.
23. Remove the drive belt from both of the hydro-
static transmission pulleys.
24. Pull the drive belt rearward and out of the way.
NOTE: The drive belt is still secured around the
electric clutch.
25. Mark and record all of the hydrostatic line con-
nections to the hydrostatic pumps.
See Figure 11.
Figure 10
Hex Bolts
and
Flat Washers
Skid Plate
Figure 11
Hydrostatic Pumps
Hydrostatic Lines