CDA CVC10SS - Manual (Page 6)

The Coffee Machine
Press to switch on the coffee machine
After a few seconds, GOOD MORNING will show on the display.
The machine will heat up, and COFFEE and STEAM will flash on the display. Once the machine is ready for use, COFFEE
and STEAM will illuminate constantly, as will the size and number of the coffees last selected (for example 1 SHORT). If
COFFEE continues to flash, add coffee beans to the container. If STEAM continues to flash (non-mains plumbed coffee
machines only) add water to the water tank.
Making espresso coffee
1. Select the coffee size
The coffee machine is equipped with three preset coffee size.
To select the size required, press
to select from the following options:
SHORT - 52ml
NORMAL - 67ml
LONG - 145ml
It is possible to adjust the amount of coffee dispensed. To do so follow the steps below.
1. When the coffee is being made, press until the required amount has been dispensed.
2. The display will show MEMO?
3. Press
to select the size that is to be set.
4. Press and hold to confirm the setting. The coffee machine will beep.
2. Select the number of coffee cups
The coffee machine can prepare one or two cups of coffee simultaneously.
To select the number required, press .
3. Make the coffee
1. Place the cup or cups under the dispenser spout.
2. Press to start dispensing. The coffee machine will dispense the selected amount of coffee. To
stop the coffee machine dispensing before the end of the preset programme, press again.
Dispensing steam
1. Press to select steam and wait for STEAM to stop flashing on the display.
2. Place the cup or container under the steam nozzle.
3. Press and hold to dispense the steam. Release the button when sufficient steam has been dispensed.
Please note:
Ensure that the spout is placed in a cup or container before pressing , as hot steam can cause scalding.
Always use the handle to move the water spout.
5