CDA CVC10SS - Manual (Page 9)

Care and Maintenance
DO NOT PERFORM ANY MAINTENANCE OR CLEANING WITHOUT FIRST SWITCHING OFF THE
POWER SUPPLY.
THE COFFEE MACHINE WILL BE HOT IMMEDIATELY AFTER USE. ALLOW IT TO COOL BEFORE CLEANING.
As the coffee machine has a stainless steel and glass surface, you should use a nonabrasive cleaner. Any abrasive cleaner
(including Cif) will scratch the surface and could erase the control panel markings. Stainless steel can be effectively
cleaned by simply using a dilute solution of water and mild detergent and drying to a shine with a clean cloth.
Remove the drip tray grid and the inner tray from the drip tray drawer and the water tank. These can be cleaned with a
soft sponge and sanitising detergent solution.
The steam/water spout can be unscrewed and removed for cleaning. This should be cleaned with a soft sponge and
hot water, or can be placed in a dishwasher. After frothing milk, it is advisable to flush the spout by dispensing a small
amount of water or steam to remove any residues of milk or froth.
A cleaning cycle should be performed both before and after a prolonged period without use. To run a cleaning cycle,
press and hold for three seconds. The coffee machine will then run a cycle by passing only water through the pipes.
Emptying the coffee grounds
COFFEE GROUNDS will show on the display after 20 coffees have been made. The coffee ground container should be
emptied before a further five coffees are made or the coffee machine will stop working.
Please note: The coffee grounds container must be emptied regularly to prevent formation of bacteria and mould.
1. Open the drip tray drawer
2. Remove the drip tray grid
3. Remove the coffee grounds container and the water container and empty and clean them both.
4. Replace the containers and the drip tray grid.
5. Close the drip tray drawer.
6. Press and hold button 2 until the coffee machine beeps.
IMPORTANT:
Steam cleaners must not be used when cleaning this appliance.
Ensure that all parts are correctly replaced after cleaning.
8