Cub Cadet ogst3305 User Manual
Page 5
ASSEMBLY INSTRUCTIONS
NOTE: The snowthrower is
shipped with oil and WITH
OUT
GAS O LINE. Af ter as sem bly, re fer to
sep a rate en gine man ual for proper
fuel and en
gine oil rec
om
men
da
-
tions.
AUGER SHEAR BOLTS
The au
gers are se
cured to the spi
ral
shaft with two shear bolts and hex
flange locknuts. Two re
place
ment hex
bolts and hex flange locknuts have
been pro
vided for your con
ve
nience.
Store in a safe place un til needed.
NOTE: Ref er ence to right hand or
left hand side of ma
chine are ob -
served from the op er at ing po si tion.
IM POR TANT: Check the ad just ments
as in structed on page 10, and make
any
fi nal
ad just ments
nec es sary
be fore op er at ing your snow thrower.
Fail ure to fol low the in struc tions may
cause dam age to the snow thrower.
•
Re
move sta
ples or break glue on the
top flaps of the car
ton. Re
move any
loose parts in
cluded with unit (i.e.,
owner’s man ual, etc.).
•
Cut along dot
ted lines and lay end of
car ton down flat. Re move pack ing ma -
te rial.
•
Roll unit out of car
ton. Check car
ton
thor oughly for loose parts or lit er a ture.
•
Re move the lower two plas
tic wing
nuts, cupped wash ers and car riage
bolts from each side of the lower han -
dle. See Fig ure 2.
•
Raise the up per han dle as sem bly un til it
locks over the lower han dle. See Fig ure
2 and 3.
•
Se
cure the up
per han
dle and lower
han
dle with the two plas
tic wing nuts,
cupped wash ers and car riage bolts pre -
vi ously re moved. See Fig ure 3.
•
Slide the shift rod con nec tor down over
the end of the lower shift rod. See Fig -
ure 4. Tap the con
nec
tor un
til it locks
on the lower shift rod.
NOTE: If the con nec tor is not prop -
erly as
sem
bled, the shift rod will
pivot and you will not be able to
shift gears or change di rec tions.
5
FIG URE 1
Shear Bolts
5/16-18 x 1.75" Lg.
(710-0891)
Hex Flange
Locknuts
5/16-18 Thread
(712-04063)
FIG URE 3
Carriage
Bolt
Wing Nuts
Washer
FIG URE 4
Lower
Chute
Crank
Chute
Cable
Cable
Guide
Lower
Shift Rod
Hairpin
Clip
Connector
Upper Shift
Rod
Upper
Chute
Crank
FIG URE 2
Wing Nuts,
Washers
and Bolts