Cub Cadet MTD P90 Series User Manual
Page 68
Advertising
P90 Series Vertical Shaft Engines
62
To re-assembly a starter motor:
1.
Press the bushing into starter gear housing until
there is 0.055” (1.4 mm) sticking out.
See Figure 6.18.
2.
Press the rotor’s upper bearing into the clutch/pinion
cover until it is flush with the cover. See Figure 6.19.
3.
Press the bushing into the clutch/pinion cover until it
is flush. See Figure 6.20.
Figure 6.18
0.055”
Figure 6.19
Bearing
Figure 6.20
Bushing is flush with the casting
Advertising