C&H Technologies M222 - Manual (Page 9)

3
1.2.3 Mechanical
The mechanical dimensions of the module are in conformance with ANSI/VITA 12-1996 for
single-wide M-Module modules. The nominal dimensions are 5.687” (144.5 mm) long
 2.082”
(52.9 mm) wide.
1.2.4 Bus Compliance
The module complies with the ANSI/VITA 12-1996 Specification for single-wide M-Modules
and the MA-Module trigger signal extension. The module also supports the optional IDENT and
VXI-IDENT functions.
Module Type: M-Module
Addressing: A08
Data: D16
Interrupts: supported
DMA: not supported
Triggers: not supported
Identification: IDENT
Manufacturer ID: 0FFF
16
(See note below)
Model Number: 068A
16
VXI Model Number: 025F
16
Note: C&H obtained the manufacturing rights from Hewlett Packard (Agilent) for this module. The
ID’s have been retained as Hewlett Packard to provide compatibility with existing SW drivers.
1.2.5 Applicable Documents
ANSI/VITA 12-1996 Standard for The Mezzanine Concept M-Module Specification, Approved
May 20, 1997, American National Standards Institute and VMEbus International Trade
Association, 7825 E. Gelding Dr. Suite 104, Scottsdale, AZ 85260-3415,
http://www.vita.com
C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com