EKLIPES EKLIPE Chrome Viper Motorcycle Cellphone & GPS Adapter - Manual (Page 2)

To Check and inspect female BMW Plug connectors slide back external housing on harness down the wires
towards the Fuse link to make room to unscrew BMW plug housing to check connectors (as seen in pictures
1, 2, & 3 below)
Note! Make sure Both Connector plugs (Red and Black) are securely connected to their mini plugs (as seen
below) inside the female BMW Plug and are securely tight. Copper Pin is Positive, Brass Pin is Negative
Make sure the positive and negative connectors inside the plug as seen in the picture above are securely tight
before you attach the ring terminals of the harness to the battery terminals as this part should be last after
making sure you have not damaged the plug.
During installation you must be careful as to NOT pull on the Female BMW Plug when you are feeding the
wiring harness from your battery to snub out to the side of your Motorcycle as seen in the picture below.
Note! DO NOT pull on any of the electrical plugs!! Pulling on the BMW Female plug will cause damage to the
plug connector wires on the inside of the dims female BMW plug and cause an electrical short in the circuit
wire and may cause severe damage or even fire. This will immediately cause a faulty installation and damage
the electrical system.
Always test and check voltage continuity on plugs before, during and after any installation for safety to make
sure you have not damaged anything during your installation.
Disclaimer: Please Note: We at Brookshire Innovations LLC do not do installations of any of our products
and therefore we do not take any responsibility or liability for any damage caused by a faulty installation from
damage done to any of the electrical wiring systems caused by the installer during installation.
As such you the customer hereby agree to install this product at your own risk and with no liability to
Brookshire Innovations LLC