EKLIPES EKLIPE Chrome Viper Motorcycle Cellphone & GPS Adapter - Manual (Page 3)

Step 2)
Follow the instructions in your Owner’s Manual to remove the seat and/or any other components
(side covers, etc.) necessary to provide access to the battery.
WARNING!
To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect battery cables
before proceeding.
WARNING!
Disconnect negative (-) battery cable first. If positive (+) cable should contact ground with negative (-) cable
connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury.
Install the positive (Red) ring terminal on the harness to the positive (+) battery post.
Attach the negative (Black) ring terminal on the harness to the negative (-) battery post.
Connect the SAE Dual-Pin connector from
the Cell Phone Adapter to the SAE Dual-Pin
Quick Connector on the EK1-153 2000 Amp
EZ Jump-Start Battery Harness.
Now you are ready to connect your Cell Phone
or any other 12 Volt accessory!