Classic Smart 4F - Manual (Page 5)

GB
5
USER INSTRUCTIONS
Classic smart 4F Universal Remote Control
INSERTING THE BATTERIES
Your new smart 4F remote control uses 2 LR03 or AAA Alkaline batteries which
must be installed before it can be used. Always use new batteries of the same
type and install the two new batteries the correct way round as shown by the
battery markings in the battery compartment on the back of the remote control.
Please dispose of used batteries as advised by the battery manufacturer.
SETTING UP YOUR smart 4F
Your smart 4F can control 4 devices. TV, VCR, SAT and DVD which can be set up
by entering either a 3 digit code from the code list included in your instruction
book or by using the library search facility. Instructions for both methods follow.
SET UP BY ENTERING A 3 DIGIT DEVICE CODE
Refer to the device code list in your instruction book and look up the 3 digit code
which corresponds to the brand of the device you wish to control. If there is more
than one code listed against the brand start with the first code.
Make a note of the code and follow steps 1) to 6) below.
1) Switch on the device you wish to control (e.g. your TV)
2) Press and hold down the required device key on the smart 4F (e.g. TV)
and at the same time press and hold down the OK key. Keep both keys pressed
down for approximately 5 seconds until the indicator light on the device key
being held down lights and remains on. Release both keys.
3) Use the number keys on the handset to enter the 3 digit code you found in
the code list.
4) The indicator will blink.
5) Press and release the device mode key (TV in this example)and the
indicator will blink 3 times. This indicates that you have now stored the code
into the handset.
6)Try all of the functions of the remote control.
7) If your device does not respond or responds incorrectly to the commands
repeat steps 1) to 6) using the next number you found against your brand in
the code list.
If the device key does not blink 3 times at step 5 an incorrect code has been
entered. Check for the correct 3 digit code for your device in the code table
and repeat steps 1) to 6).
Repeat the above procedure to enter the codes for your VCR, SAT and DVD
using the appropriate device key on the smart 4F and code from the device
code list.
Make a note of the device codes used on the label inside the battery
compartment should these be needed again in the future.
smart4F.indd 5 23.09.2008 17:10:40 Uhr