Hangar 9 Twist 60 ARF - Manual (Page 11)

11
Required Parts
•.Landing.gear.w/wheels. •.Fuselage
•.1".(25mm).tail.wheel. •.Rudder.assembly
•.Stabilizer.assembly. •.4-40.locknut.(3)
•#4.washer.(3). •#8.washer.(3)
•.5/64".wheel.collar. •.4-40.setscrew
•.8-32.x.3/4".machine.screw.(3)
•.Pre-assembled.4
.
3 /
4
".(120mm).rudder.linkage
•.Pre-assembled.4
.
1 /
4
".(108mm).elevator.linkage
Required Tools and Adhesives
•.Servo.w/hardware.(2). •.Long.servo.arm.(2)
•.Adjustable.wrench
•.Threadlock
•.18".(458mm).servo.extension.(2)
 .Step 1
Attach.the.landing.gear.to.the.bottom.of.the.fuselage.using.
three.8-32.x.3/4".machine.screws.and.three.#8.washers..
Put.a.little.threadlock.on.the.screws.to.prevent.them.from.
vibrating.loose.during.flight.
 .Step 2
Slide.the.threaded.rods.from.the.rudder.assembly.into.the.
holes.in.the.stabilizer..The.two.forward.rods.go.through.
the.stabilizer.as.shown.
 .Step 3
Slide.the.rudder/stabilizer.onto.the.fuselage..Guide.the.
threaded.rods.through.the.stabilizer.saddle.then.through.
the.holes.in.the.bottom.of.the.fuselage.
 .Step 4
Secure.the.tail.assembly.to.the.fuselage.using.three..
#4.washers.and.three.4-40.locknuts..Do.not.over-tighten.
the.nuts.and.crush.the.fuselage.
Section 2: Landing Gear and Tail Installation