Hangar 9 Twist 60 ARF - Manual (Page 9)

9
 .  .Step 3
Prepare.an.aileron.servo.by.installing.the.grommets.
and.brass.eyelets.provided.with.the.servo..Secure.
a.9".(228mm).servo.extension.to.the.servo.using.a.
commercially.available.connector.or.with.string.or.
unwaxed.dental.floss.
 .  .Step 4
Tie.the.string.that.exits.the.servo.opening.to.the.servo.
extension..Use.the.string.to.pull.the.servo.lead.through.
the.wing..Use.a.piece.of.tape.to.keep.the.extension.from.
falling.back.into.the.wing.
 .  .Step 5
Place.the.servo.into.the.opening.with.the.servo.output.
towards.the.trailing.edge.of.the.wing..Use.a.felt-tipped.pen.
to.mark.the.locations.for.the.four.servo.mounting.screws.
 .  .Step 6
Remove.the.servo.and.drill.the.locations.for.the.servo.
mounting.screws.using.a.1/16".(1.5mm).drill.bit...
Apply.a.couple.drops.of.thin.CA.to.each.hole.to.harden.
the.wood,.which.will.help.in.preventing.the.screws.from.
damaging.the.wood.
Section 1: Aileron Servo Installation