Hardy HI 6300 Series - Manual (Page 2)

Panel Installation:
1. Use template provided to drill the hole pattern into panel.
2. Install the display onto the panel using 4mm nuts and washers,
tighten until gasket is compressed and display bezel comes in
contact with the panel.
3. Connect display cable to display and then to the instrument.
4. Slide the instrument onto threaded rods and secure in place with
8mm x 4mm retaining nuts (do not over tighten instrument
retaining nuts, overtighting could cause the instrument to crack).
DIN Rail Installation:
1. Use template provided to drill the hole pattern into panel
2. Install the display panel using 4mm nuts and washers, tighten until
gasket is compressed (4mm screws with length appropriate to panel
thickness can be used in place of the 4mm rods sent with the unit).
3. Place the instrument onto the DIN rail, slide DIN rail clip up until it
snaps into place to secure.
4. Connect display cable to display and instrument (le
ngthen the cable
as needed by using a thin screwdriver to release and replace wires
between the two connectors).