Hardy HI 6300 Series User Manual
Page 7
There are two simple rules for the IP Address:
It must have the same network
identifier as the computer
It must have a different node
identifier than the computer.
5) On a PC running windows, open Internet Properties (TCP/IP).
6) Click in the ‘Use the Following IP Address’ checkbox; then enter the
following into the TCP/IP Properties dialog.
IP Address = 192.168.0.101
Subnet Mask = 255.255.255.000
7) Select OK on the TCP/IP Properties dialog box. The computer is now
fully configured. To return the computer to the original network
settings, return to the ‘Internet Properties (TCP/IP) dialog, select
‘Obtain an IP address automatically,’ and click OK.
8) The HI 6300 series instrument is now configured to communicate
with the PC. Enter the HI 6300 series instrument IP address into the
Windows PC Web browser to access the embedded web browser.
For example: http://192.168.000.100
See the HI 6300 User’s Guide for setting up Ethernet-UDP and Modbus-
RTU communication protocols.
Diagnostics:
Section used for diagnostics of system. Refer to User’s
Guide if troubleshooting and use of diagnostics menu is
required.
Display:
Section used for adjusting various aspects of the display,
including contrast and brightness.
Filter:
Section used to stabilize weigh readings in an unstable
environment.
WAVERSAVER: Press the enter button and use the arrow keys to select
the appropriate setting. WAVERSAVER eliminates
unwanted noise and is typically set at 1.0 Hz.
NumAverages: Set the number of readings to average to provide a
stable weight.