Inovonics EN7016 User Manual
Page 3
© Inovonics, 2011 - www.inovonics.com
3
Figure 7 EN1223SK Frequency Band Selection Options
4. Close the housing and replace the three housing screws.
5. Press the Reset button to complete frequency band selection.
Figure 8 EN1223SK External View
3.2 Select ES1210SK Survey Transmitter
Frequency Band
The ES1210SK survey transmitter is shipped with the frequency
band set for North America. If you are using the ES1210SK in
Australia or New Zealand, you will need to set the frequency band
for your geographic area.
1. Use the small flat-blade screwdriver to press the housing
release tab on the top or bottom of the receiver and separate
the housing.
2. Place a selection jumper on the appropriate frequency band
selection pins (8).
• Place the jumper on the left two pins, marked AUS, to set the
frequency range to 915-928 MHz for Australia.
• Place the jumper on the right two pins, marked NZ, to set the
frequency range to 921-928 MHz for New Zealand.
• Leave the jumper off the pins to set the frequency range to
902-928 MHz for North America.
Note: North America is also selected when the jumper is either
attached to one pin or no pins. Attaching the jumper to one pin can
prevent the jumper from being lost when selecting the North
America.
Figure 9 ES1210SK Components.
Figure 10 ES1210SK Frequency Band Selection Options
3. Press the Reset button to complete frequency band selection.
4. Replace the housing.
4 Configure the Survey Receiver
Observe the following rules to navigate the display screens and
select options:
• Press the Up and Down buttons to highlight (CAPITALIZE)
menu items on the display screen.
• Press the Enter button to select highlighted menu items.
• Press the Exit button to exit the current display screen. The
display will return to the last higher-level display screen.
Note: The EN4016SK survey receiver is set for North America by
default. If you are using an EN4016SK survey receiver to perform
your site survey in North America there is no need to configure the
survey receiver’s frequency band for your geographic area.
Note: The EN4016SK survey receiver will turn itself off if no key is
pressed for 30 minutes, unless the survey receiver is in one of the
P
OINT
S
TATUS
screens. If in one of the P
OINT
S
TATUS
screens, the
survey receiver will turn itself off after five hours.
1. Press the Power button on the EN4016SK keypad to power on
the receiver. When the receiver information screen displays,
press Enter to advance to the main menu.
Reset
Button
On/Off
Button
Transmit
LED
On/Off
Button
Reset
Button
Frequency
Band Selection
Pins
Transmit
LED