Inovonics EN7016 User Manual
Page 4
© Inovonics, 2011 - www.inovonics.com
4
Figure 11 Survey Receiver Keypad.
The M
AIN
M
ENU
displays:
Figure 12 The Main Menu, Point Status Highlighted
The M
AIN
M
ENU
displays the model number and frequency band on
the first line. If the battery is low, the first line will also display the
low battery symbol. The low battery symbol will also display on
many other screens.
The M
AIN
M
ENU
offers the following choices:
Point Status Select to view point status. See section 7, “Perform a
Site Survey using Survey Transmitters” for more information.
Register Point Select to register a point. See section 5, “Register
End-Devices” for more information.
Delete Point This is selected to delete any particular point or all
points that have been registered.
Receiver Setup Select to configure the receiver.
2. Press the Down button three times to highlight R
ECEIVER
S
ETUP
.
Figure 13 The Main Menu, Receiver Setup Highlighted
3. Press Enter to select. The R
ECEIVER
S
ETUP
menu displays.
Figure 14 The Receiver Setup Menu, Sounder Vol Ctrl
Highlighted
R
ECEIVER
S
ETUP
includes the following options:
Sounder Vol Ctrl Select to change the volume for the EN4016SK
sounder. The volume is given as a percentage, with a default of
100%. Press the Up/Down buttons to raise or lower the volume.
Headphone Vol Ctrl Select to change the volume for the optional
headphones. The volume is given as a percentage, with a default
of 100%. Press the Up/Down buttons to raise or lower the volume.
Restore Defaults Select to restore all default receiver
configuration settings.
Caution: Choosing restore defaults will erase all programmed
points. If you choose to restore defaults you will need to re-register
all points.
Freq Band Setup If you are using an EN4016SK, select to choose
the frequency band appropriate for your geographic area. The
options are: US, A
USTRALIA
and N
EW
Z
EALAND
. US is the default.
Use the Up/Down buttons to highlight the selection for your
geographic area and press Enter to select.
4. Press the Down button three times to highlight F
REQ
B
AND
S
ETUP
.
Figure 15 The Receiver Setup Menu, Freq Band Setup
Highlighted
5. Press Enter to select F
REQ
B
AND
S
ETUP
. The F
REQ
B
AND
S
ETUP
screen displays.
Figure 16 The Frequency Band Setup Screen, United States
Highlighted
6. Use the Up/Down buttons to highlight your geographic area,
and press Enter to select.
7. Press the Exit button until the M
AIN
M
ENU
displays.
5 Register End-Devices
Before beginning the site survey, you must register all survey
transmitters and/or any other end-devices you will use to conduct
the survey. To register end-devices:
A Power Button
B Up Button
C Down Button
D Enter Button
E Exit Button
F Backspace Button
A
B
C
D
F
E