Detection settings, Display settings, System settings – KEYENCE FS-N10 Series User Manual
Page 5: Two output
5
Detection Settings
*1 Press the
button to set between the range of
and (ms).
*2 Press the
button to set the retouch sensitivity to a range of between
.'W and .'W
and set the warning output level to a range of between
12 and 2.
*3 Press the
button to toggle between
Q((/Q0/-''2.
*4 Can be set between the range of
and .
*5 Can be set between the range of
and .
*6 Can be used only for the types with the external input.
Note that these functions can be used via communication when connecting with the network
unit NU Series.
*7 Only monitor output types (FS-N11MN).
Display Settings
*1 Press the
button to toggle between
5VF/2`2A/D`DA/2AD`/2`DA
*2 Press the
button to set between the range of
2 and 2.
System Settings
*1 Main unit only.
Two Output
*2
*1 Press the
button to set between the range of
and (ms).
*2 Only 2 output types (FS-N13N/N13P/N14N/N14P/N13CP/N14CP).
Normal (light intensity)
detection mode
DATUM1 mode *
2
Timer OFF
Off-delay timer *
1
On-delay timer *
1
One-shot timer *
1
DATUM2 mode *
2
Area detection mode
Rising Edge Detection Mode
Falling Edge Detection Mode
Settings complete
Go to display setup mode
Go to system setup mode
Return to original
detection setup mode
External input off
External calibration input
Preset input
Zero shift input
Reset input
Light transmission OFF input
Pause mode transition input *
3
Sleep mode transition input
Light emission power selection *
4
Analog scaling *
5
Return to normal display
*6
*7
MODE
MODE
MODE
Normal display method
Reverse display
Settings complete
Go to system setup mode
Go to detection setup mode
Return to original display setup mode
Sub-display off
Extended display
Bar display
Excess gain display
Light intensity hold display *
1
Excess gain hold display *
1
L-on / D-on display
Disable the saturation of the
Preset function
Enable the saturation of the
Preset function *
2
Return to normal display
MODE
MODE
Disable APC
Enable APC
Settings complete
Go to detection setup mode
Go to original display setup mode
Return to system setup mode
Normal operation
Twice the number of
interference-prevention units as
56&
(response time 2 times slower)
Eco feature off
Enable eco feature
Reduce power consumption
(response time 4 times slower)
Disable common key operations
Enable common key operations
Standard current value display
Maximum current value display
(4 times hysteresis)
Return to normal display
*1
Light intensity detection mode
Limit setting output mode
Auto reset
User reset
Warning output mode
Timer OFF
Off-delay timer *
1
On-delay timer *
1
One-shot timer *
1
Settings complete
Return to normal display
MODE