Cary Audio Design Cinema 11 - Manual (Page 38)

SETUP MENU
37
To set Analog in Config:
1. Press the SETUP button to enter the SETUP MENU.
The SETUP MENU/SPEAKER appears.
2. Press the  button until INPUT is selected.
The SETUP MENU/ INPUT menu appears.
3. Press the ENTER button to enter the CHANGE INPUT NAMES setup menu.
4. Press the  button until SET ANALOG IN CONFIG is selected.
5. Press the ENTER button to enter the INPUT 1 analog in config menu.
6. Use the  and  buttons to select the mode.
You can select the BYPASS mode or DSP mode.
7. Press the  button when you have made a selection.
Repeat steps 6 for the INPUT 2, INPUT 3, INPUT 4, INPUT 5, INPUT 6, INPUT 7, INPUT
8, 7.1 IN and TUNER.
8. Press the  button to select BACK and press the ENTER button to return to the SET
ANALOG IN CONFIG. menu, or press the SETUP button to exit the SETUP MENU.
NOTE: As you can see from these settings, it is possible to use the Cinema 11 as an
analog stereo preamp and as a surround sound preamplifier at the same time.
RADIO
The Cinema 11 radio allows the FM tuner section to select frequency ranges for USA/EURO or
JAPAN and it can set AM frequencies for USA 10kHz step or to 9kHz step to match the broadcasts
of stations outside North America.
- RADIO
- Set FM frequency
- Set AM frequency step
To set FM frequency:
1. Press the SETUP button to enter the SETUP MENU.
The SETUP MENU / SPEAKER appears.
2. Press the  button until INPUT is selected.
The SETUP MENU/INPUT menu appears.
3. Press the  button until RADIO is selected.
4. Press the ENTER button to enter the SET FM FREQ menu.