Cary Audio Design Cinema 11 - Manual (Page 40)

SETUP MENU
39
Listening to the Radio
The following steps show you how to tune in to FM and AM radio broadcasts using the automatic
(search) and manual (step) tuning functions.
1. Press the AM or FM button on the remote
handset or front panel to select the band.
2. Tune to a station. There are two ways to
do this:
Automatic tuning and saving station
To search for stations in the currently
selected band, press TUNER SCAN button
in the remote handset. The Cinema 11 will
start searching for the next station, one
after another, beginning with the current
station, for approximately 5 seconds each.
Station frequencies will be assigned to
station numbers in the memory.
Manual tuning
To change the frequency one step at a
time, press TUNER SEEK.
3. Saving station presets
If you often listen to a particular radio
station, it's convenient to have the
processor store the frequency for easy
recall whenever you to listen to that
station. This saves the effort of manually
tuning in each time. This processor can
memorize up to 30 stations.
Tune to a station you want to memorize.
Press the MEMORY button and the display
shows SAVE P00?
Press the NUMBER button to select a station preset. It will automatically save the station.
4. Improving FM stereo sound
If the TUNED or STEREO indicators don't light when tuning to an FM station because the
signal is weak, press the FM MODE button to switch the processor into mono reception
mode. This should improve the sound quality and allow you to enjoy the broadcast. An
outside antennae or a cable FM connection will improve reception.
5. Listening to station presets
You will need to have some presets stored to do this, See Saving station presets above if
you haven't done this already. Press AM or FM to select the band. Press the number on the
remote control to recall the station preset.