KEYENCE AutoID - Manual (Page 48)

3-16
MANAGING PROJECTS
3
3-4 Editing Setup Files
■ Sending parameters
To set parameters preset on AutoID Navigator to a device, following the procedure below to send
the parameters.
1
Click (write setting) at the top right of the screen.
2
The confirmation dialog box is displayed. Click the "OK" button.
The communication in progress dialog box is displayed and parameters start to be sent.
3
The write completion dialog box is displayed. Click the "OK" button.
This completes transmission of the parameters.
When the RF-500 Series is used, the parameter settings file and the macro set-
tings file are created as separate files. The parameter settings and the macro set-
tings need to be sent separately.
Note