KEYENCE BL-180 - Manual (Page 44)

3.3 Setup Software Operating Procedure
36
3.3.7 UPC/EAN setup
1. Select Read EAN 8 code, Read UPC-A[EAN13] code or Read UPC-E to
enable to read.
If you select Read UPC-A[EAN13] code, the following information appears,
asking you to select which digits you want to output on UPC-A.
If you select Read UPC-E, the following information appears, asking if you
want to send data with the leading zero-suppressed.
2. You can use the same setting procedure as for CODE39 for Max code length
output and Specify label orientation. However, the setting range of Effective
and Starting in Max code length output is limited to the code length of the
readout UPC/E code.
• Although the check-digit parameter is not provided on the screen, the system
internally calculates it using modulus 10/Weight3. (The calculated data is
sent.)
3.3.8 CODE128 setup
1. The setting range of code length depends on the start character type CODE-
A to C (see page 70).
• CODE-A and B --- 1 to 32
• CODE-C --- 2 to 64
The code length does not include the start/stop character or check-digit. Also,
FNC1 to 4 (function codes), SHIFT, and CODE-A to C are excluded from the
code length.