KEYENCE BL-180 - Manual (Page 66)

4.3 Command Communication
58
Setting Communication Parameters
Function command being sent Respons
e
Description Error
Code
Setting baud rate Change WP35n OK N= 0: 9600 bps
1: 4800 bps
2: 2400 bps
3: 1200 bps
4: 600 bps
5: 38400 bps
6: 31250 bps
7: 19200 bps
00, 02
05, 08
14
Confirm RP35 035n
Setting data bit length Change WP30n OK n= 0: 7 bits
1: 8 bits
00, 02
05, 07
14
Confirm RP30 30n
Setting parity check
* To set the parity type, use the
command below. Change WP31n OK
n= 0: Disable
1: Enable Confirm RP31 31n
Setting parity type Change WP32n OK n= 0: Even
1: Odd Confirm RP32 32n
Setting Stop bit Change WP33n OK n= 0:1 bit
1: 2 bits Confirm RP33 33n
Setting handshaking protocol 1
* To specify the protocol, use
the command below. Change WP07n OK
n= 0: No protocol
1: Set protocol Confirm RP07 07n
Setting handshaking protocol 2 Change WP08n OK n= 0: PASS/RTRY handshaking
1: ACK/NAK handshaking Confirm RP08 08n
Setting RTS/CTS handshaking Change WP22n OK n= 0: Disable
1: Enable Confirm RP22 22n