Kimber Ultra Carry - Manual (Page 35)

35
8. Place the takedown pin tool securely in the
hole and relieve spring pressure (sometimes it
helps to have someone else insert the
takedown pin).
9. The compressed spring and Guide Rod
Assembly is now ready for reassembly into
your slide.
RECOIL SPRING REPLACEMENT–ULTRA CARRY
The custom shop will replace both springs if you
send in the complete assembly to Yonkers,
however, the double spring assembly is normally
replaced as a complete unit.
CLEANING
Always run the cleaning rods from the chamber
end.
1. Disassemble pistol as described in previous
section.
2. Run a wet patch through the bore. Let soak a
few minutes. (Always read the manufacturers’
directions of the bore cleaner you are using.)
3. Run a dry patch through to remove loose
crud/deposits.