Kimber Ultra Carry User Manual
Page 37
37
b. Disconnector on top of frame - Small drop.
c. Barrel Hood - two drops, spread on hood.
d. Barrel Locking lugs inside Slide and on
Barrel - one drop on each lug.
e. Barrel Link- one drop behind link.
f. Slide Stop pin - one drop, spread with finger.
g. Outside of Barrel - Oil. Do not over oil,
spread with fingertip.
h. Cock Hammer - one drop in between the
hammer and frame.
i. Assemble gun. Rack the Slide 5-6 times,
dry fire. Wipe off excess oil from gun.
j. Make sure, if you have stored the gun with
oil in the barrel and chamber, that you run
a dry patch through the barrel to clear it of
the oil before you fire the gun.
3. Reassemble as previously described.
The key is moderation. Not enough oil and your
gun may not function properly and lead to undo
wear. Too much oil and you risk attracting damaging
dirt and debris to the bearing surfaces causing
undo wear and potential functioning problems. All
metal parts even Stainless Steel should be lightly
lubricated because
RUST IS NEGLECT!
A cloth impregnated with Silicone is good for this
purpose.