Panasonic NE-1054F - Manual (Page 14)

C. Programming the Double Quantity Pad — For multiple portion heating:
Your oven is factory set to automatically double the programmed time for multiple portion heating — this is the correct setting
for heating multiple portions of most small foods items. No further programming of the time is necessary for these food items.
The time required to heat multiple portions of some large platters and most bulk food loads is slightly less than double that of a
single portion.
This model incorporates a Multiple Portion Heating Custom Program feature that allows you to customize the heating time
and/or power level for multiple portions of your menu items.
For example, If Memory Pad 3 is set for 6 minutes at DEFROST, 12 minutes at DEFROST is set for double quantity heating
automatically. However, if your own tests have determined that the correct heating times required is less {only 10 minutes 30
seconds at DEFROST) tor two portions, the “Multiple Portion Heating Custom Program” feature can be programmed for 10
minutes 30 seconds at DEFROST.
't
lO
o
Example; To program 30 seconds at HIGH Power on Memory Pad Number 2
1 .
2.
3.
PROG.
DOUBLE
QUANTrrV
(x2)
20
•Press the PROG. Pad.
NOTE:
•If no PROG Indicator appeares in the
Display Window, “Program Lock" should be
cancelled (see page 15).
•Do not keep pressing PROG. Pad tor
more than 30 seconds, or a false
failure code may result,
•Press DOUBLE QUANTITY (x 2) Pad.
•Press Memory Pad 2.
The pad number and the previously
selected time and power level for
multiple portion heating will
appear in the Display Window.
•The pad number and Stage Heating Indicator
will appear in the Display Window again.
Display Window
4.
*2 PROG 1
lllll.
•Press the POWER Level Selector Pad
once. The Memory Pad display will
POWER go out.
5.
:ao
K
3;30
•Press the Memory Pads 3, 0.
X2 PROG 1_ _
3 0
6 .
PROG.
•Press the PROG. Pad again.
You have completed programming the
selected Memory Pad for multiple
portion heating.
•2 seconds later, the setting for single
stage heating will appear in the Display Window.
X2 PROG _____ >
X2 PROG 1
3 0
•2 seconds later, the Display Window
will go blank.
NOTE: • Program the remaining Memory Pad as desired by repeating steps 1-6 above. (You may insert up to 10 memory
programs.)
DO NOT OPEN THE OVEN DOOR while programming.
• When the PROG indicator is blinking, the program can be cancelled and/or the pad erased by pressing STOP/RESET
Pad.
-
1 4
-