Abstract Data ADE-10 - Manual (Page 3)

Page 3 of 7
CALIBRATION POINT: Removes DC offset at both outputs. Factory calibrated to 0V DC (Please see
‘CALIBRATION’ on page 7 of this guide)
POWER CONNECTOR: Doepfer-style 16-pin IDC Socket. The ADE-10 uses the Doepfer standard for
power connection and cable orientation. The RED stripe on the supplied
power cable connects to the NEGATIVE (-12V) rail on the ADE-10 with the
RED stripe facing DOWN. This is marked on the back of the ADE-10 PCB as
“-12 RED”.
(Please see ‘PRECAUTIONS’ on page 7 of this guide)
© 2011 Abstract Data Ltd. http://www.abstractdata.biz [email protected] Version 1.0 October 2011
2: Rear
3: Signal Flow
STAGE 1
SHAPING
STAGE 2
FOLDING
STAGE 3
FEEDBACK
OUTPUT
GAIN/ATTEN
FULL-WAVE
OUTPUT
HALF-WAVE
OUTPUT
INPUT
GAIN/ATTEN